Try a 2-inch belt and see what happens.
Hello everyone.
I can‘t come to a conclusion on this for myself, therefore I would like to have some input.
Until recently I used a 4“ Nylon Belt from 2Pood Performance. Never had an issue with it getting loose or something. Maybe because I wasn‘t moving weights heavy enough.
With this 4 inch belt, all the exercises were ok, except the Deadlift. It pinched into my belly on the lower side of the belt. So, as I remembered Rips recommendation on a 3 inch belt, I ordered the Starting Strength belt.
Everything was fine. Until I bruised a floating rib (my guess) on the right side doing Deadlifts.
There are several Discussions on this Forum regarding that, which I already read. And I watched Rays Video „How does a weightlifting belt help you in the Gym?“, and numerous others.
But I still have some questions.
The belts mid should be positioned roughly on the belly button. If I do so, it sits perfectly fine on my gut, and on the side its just above my hip bones. So everything is fine.
If I close the belt tight, it starts to get tricky. I tried to measure the distance between my hip bones and the lowest point of the rib cage on my sides, and it‘s only 2.6 inches max.
Is this possible? I mean; if this is the case, 3 inch would be to wide for me, right? Should the belt sit underneath the floating ribs, or is it ok for them to push against the belt? I guess, I lost a bit of form during the Deadlift, and the tight fitting belt pushed the rib a bit upwards. I didn‘t feel anything whilst training. It only started to hurt that evening.
Try a 2-inch belt and see what happens.
Thank you Rip.
My idea was quite the same. As I‘m living in Germany, there‘s not much stuff to find within the European Union. I couldn‘t find anything below 2.3 inch, so I went with such a belt.
Doesn‘t make a big difference to the 3 inch Starting Strength belt. So I‘ll return that belt.
I thought about cutting my Starting Strength belt down to 2 inch,… but without being absolutely sure that this is the right way, I won‘t do it.
Finished the Training today with a 4 inch belt. My bruised Rib hurt the least that way.
Game Plan so far is to continue Training with the 4 inch belt and the 3 inch, depending on what feels better.
You can’t cut a three-inch belt down by hand. You will ruin it.
Have you thought about simply tilting the belt so that it rides lower in front?
You could try just a normal leather belt, like you’d use for jeans. They are a bout 1.5 inches. It’ll do the job, and they are cheap like borscht.
They will also break, like borscht.
@Satch12879
I asked a friend of mine, Shoemaker. She said, since there‘s no Seam on the edge, I could use a sharp scalpel and cut alongside a metal ruler. Or I could give it to her.
But thanks for the warnings.
I use one of those suede 3" belts and it works well. I do however have a small bruise from the same thing the OP is dealing with and always seems to be the deadlift movement that causes it. It's just a bruise...I just assume its because I'm still a bony puke.
I have to update my Training Log in the Forum. But to give an update on my Situation in this Thread; trained the last week and this week. I reduced the weights, and went up each Training day.
I used a belt starting with the last warm up Set. Right now, I can inhale and brace as hard as possible, and don‘t feel anything at all. During Work-Sets with a belt it‘s a bit different. With the 3“ belt, it makes problems as soon as I have it tight enough. I can use the 4“ belt way tighter than the 3“ without feeling the ribs. I wouldn‘t even call it a Pain. It‘s just a nagging feeling. But as I‘m concerned not to make it worse again, I‘ll continue this way.