i retract as far as i can
i retract as far as i can
Me too. The arch isn't the only reason you keep your shoulderblades back, you do it to keep your body stable and to press from the chest not use your shoulders too much
I disagree, I prefer benching in a rack to using a spotter. Your chances of finding a competent spotter are close to 0. Since you're actually doing useful training, you're allowed to hog the power rack. (But if the gym is busy and someone wants to work in, then definitely don't be an ass)
I disagree with pinning the shoulder blades back together as hard as possible for raw benching, I definitely side with CT and his "shrug the shoulders" cue and feel it has helped save the shoulders immensely. IMO this is by far the best way to set up for raw benching, shirted bench changes things at the bottom of the lift and the shoulders are not nearly as comprimised, so a bigger arch and retracted the shoulder blades is beneficial there as it both reduces the rom and tightens the sweet spot in the shirt, but when benching raw, this method is much much more shoulder friendly.
No they wont, they will actually pull the lats together and DOWN, lengthening the traps. Bunching the lats up is harder on the shoulder joint than being a little more flat backed and shrugging. There is a big difference between focusing on squeezing the lats together and focusing on simply shrugging the shoulders as high as possible and driving the body weight back to a flatter upper torso area.
also, if you squeeze your lats together maximally, then try to shrug, your chest drops significantly as the scapula move up. Most people will set up with lats pulled back and down to raise the chest as high as possible. I am saying this is not the best way for a raw lifter to set up, and it can cause a lot of shoulder problems along with it.